Resistance between data/Addr pins and GND ranges from 1k to 1M, is this normal?
After soldering a 132-pin surface mount DSP, I checked if there are short circuits or not using "GreenLee DM-110" multimeter. I found that the resistance between data or address pins and GND ranges from ~1K Ohm to 1M Ohm.
I know that I should measure an open circuit or several (hundreds!) mega ohms. Why is the resistance too low? Can this cause any danger to DSP operation?
After soldering a 132-pin surface mount DSP, I checked if there are short circuits or not using "GreenLee DM-110" multimeter. I found that the resistance between data or address pins and GND ranges from ~1K Ohm to 1M Ohm.
I know that I should measure an open circuit or several (hundreds!) mega ohms. Why is the resistance too low? Can this cause any danger to DSP operation?
No comments:
Post a Comment